ZyXEL Communications GS3700 Series Guide de l'utilisateur télécharger pdf (Page 52)

Chapter 5 System Status and Port Statistics

GS3700/XGS3700 Series User’s Guide

The following table describes the labels in this screen.

Table 6 Status

LABEL DESCRIPTION

Port This identifies the Ethernet port. Click a port number to display the Port Details screen

(refer to Figure 19 on page 53).

Name This is the name you assigned to this port in the Basic Setting > Port Setup screen.

Link This field displays the speed (such as 100M for 100 Mbps, 1000M for 1000 Mbps, or 10G

for 10 Gbps) and the duplex (F for full duplex). This field displays Down if the port is not

connected to any device.

State If STP (Spanning Tree Protocol) is enabled, this field displays the STP state of the port. (See

Section 11.1.3 on page 113 for more information).

If STP is disabled, this field displays FORWARDING if the link is up, otherwise, it displays

STOP.

PD (For PoE models only) This field displays whether or not a powered device (PD) is allowed to

receive power from the Switch on this port.

LACP This fields displays whether LACP (Link Aggregation Control Protocol) has been enabled on

the port.

TxPkts This field shows the number of transmitted frames on this port.

RxPkts This field shows the number of received frames on this port.

Errors This field shows the number of received errors on this port.

Tx KB/s This field shows the transmission speed of data sent on this port in kilobytes per second.

Rx KB/s This field shows the transmission speed of data received on this port in kilobytes per second.

Up Time This field shows the total amount of time in hours, minutes and seconds the port has been

up.

Clear Counter Type a port number, select Port and then click Clear Counter to erase the recorded

statistical information for that port, or select Any to clear statistics for all ports.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 415 416

Pas de commentaire

ZyXEL Communications GS3700 Series Guide de l'utilisateur Page 52