
Chapter 40 ARP Setup
GS3700/XGS3700 Series User’s Guide
328
40.2.2 Static ARP
Use this screen to create static ARP entries that will display in the Management > ARP Table
screen and will not age out. Click the link next to Static ARP in the IP Application > ARP Setup
screen to display the screen as shown.
Figure 218 IP Application > ARP Setup > Static ARP
The following table describes the related labels in this screen.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 165 IP Application > ARP Setup > ARP Learning (continued)
LABEL DESCRIPTION
Table 166 IP Application > ARP Setup > Static ARP
LABEL DESCRIPTION
Active Select this check box to activate your rule. You may temporarily deactivate a rule without
deleting it by clearing this check box.
Name Enter a descriptive name (up to 32 printable ASCII characters) for identification purposes.
IP Address Enter the IP address of a device connected to a Switch port with the corresponding MAC
address below.
MAC Address Enter the MAC address of the device with the corresponding IP address above.
VID Enter the ID number of VLAN to which the device belongs.
Port Enter the number of port to which the device connects.
Add Click this to create a new entry or to update an existing one.
This saves your changes to the Switch’s run-time memory. The Switch loses these changes
if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Clear Click Clear to set the above fields back to the factory defaults.
Commentaires sur ces manuels