ZyXEL Communications GS3700 Series Guide de l'utilisateur télécharger pdf (Page 205)

Chapter 22 Multicast

GS3700/XGS3700 Series User’s Guide

205

Note: A port can belong to more than one multicast VLAN. However, IP multicast group

addresses in different multicast VLANs cannot overlap.

Figure 122 Advanced Application > Multicast > Multicast Setup > MVR > Group Configuration

The following table describes the labels in this screen.

Table 94 Advanced Application > Multicast > Multicast Setup > MVR > Group Configuration

LABEL DESCRIPTION

Multicast VLAN

Select a multicast VLAN ID (that you configured in the MVR screen) from the drop-down list

box.

Group Name Enter a descriptive name for identification purposes.

Start Address Enter the starting IP multicast address of the multicast group in dotted decimal notation.

Refer to Section 22.1.1 on page 184 for more information on IP multicast addresses.

End Address Enter the ending IP multicast address of the multicast group in dotted decimal notation.

Enter the same IP address as the Start Address field if you want to configure only one IP

address for a multicast group.

Refer to Section 22.1.1 on page 184 for more information on IP multicast addresses.

Add Click this to create a new entry.

This saves your changes to the Switch’s run-time memory. The Switch loses these changes if

it is turned off or loses power, so use the Save link on the top navigation panel to save your

changes to the non-volatile memory when you are done configuring.

Cancel Click Cancel to begin configuring this screen afresh.

MVLAN This field displays the multicast VLAN ID.

Group Name This field displays the descriptive name for this setting.

Start Address This field displays the starting IP address of the multicast group.

End Address This field displays the ending IP address of the multicast group.

1 2 ... 200 201 202 203 204 205 206 207 208 209 210 ... 415 416

Pas de commentaire

ZyXEL Communications GS3700 Series Guide de l'utilisateur Page 205