ZyXEL Communications GS3700 Series Guide de l'utilisateur télécharger pdf (Page 343)

Chapter 42 Access Control

GS3700/XGS3700 Series User’s Guide

343

42.3.4 Configuring SNMP

From the Access Control screen, display the SNMP screen. You can click Access Control to go

back to the Access Control screen.

Figure 227 Management > Access Control > SNMP

The following table describes the labels in this screen.

Table 177 Management > Access Control > SNMP

LABEL DESCRIPTION

General Setting Use this section to specify the SNMP version and community (password) values.

Version Select the SNMP version for the Switch. The SNMP version on the Switch must match the

version on the SNMP manager. Choose SNMP version 2c (v2c), SNMP version 3 (v3) or

both (v3v2c).

Note: SNMP version 2c is backwards compatible with SNMP version 1.

Get Community Enter the Get Community string, which is the password for the incoming Get- and

GetNext- requests from the management station.

The Get Community string is only used by SNMP managers using SNMP version 2c or

lower.

Set Community Enter the Set Community string, which is the password for the incoming Set- requests

from the management station.

The Set Community string is only used by SNMP managers using SNMP version 2c or

lower.

Trap Community Enter the Trap Community string, which is the password sent with each trap to the

SNMP manager.

The Trap Community string is only used by SNMP managers using SNMP version 2c or

lower.

Trap Destination Use this section to configure where to send SNMP traps from the Switch.

Version Specify the version of the SNMP trap messages.

IP Enter the IP addresses of up to four managers to send your SNMP traps to.

Port Enter the port number upon which the manager listens for SNMP traps.

1 2 ... 338 339 340 341 342 343 344 345 346 347 348 ... 415 416

Pas de commentaire

ZyXEL Communications GS3700 Series Guide de l'utilisateur Page 343