
Chapter 26 VLAN Mapping
GS3700/XGS3700 Series User’s Guide
250
26.3 Configuring VLAN Mapping
Click the VLAN Mapping Configure link in the VLAN Mapping screen to display the screen as
shown. Use this screen to enable and edit the VLAN mapping rule(s).
Figure 154 VLAN Mapping Configuration
The following table describes the labels in this screen.
Table 119 VLAN Mapping Configuration
LABEL DESCRIPTION
Active Check this box to activate this rule.
Name Enter a descriptive name (up to 32 printable ASCII characters) for identification purposes.
Port Type a port to be included in this rule.
VID Enter a VLAN ID from 1 to 4094. This is the VLAN tag carried in the packets and will be
translated into the VID you specified in the Translated VID field.
Translated VID Enter a VLAN ID (from 1 to 4094) into which the customer VID carried in the packets will
be translated.
Priority Select a priority level (from 0 to 7). This is the priority level that replaces the customer
priority level in the tagged packets or adds to the untagged packets.
Add Click this to create a new entry or to update an existing one.
This saves your changes to the Switch’s run-time memory. The Switch loses these changes
if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to reset the fields to your previous configuration.
Index This is the number of the VLAN mapping entry in the table. Click on an index number to
change the settings.
Active This shows whether this entry is activated or not.
Name This is the descriptive name for this rule.
Port This is the port number to which this rule is applied.
VID This is the customer VLAN ID in the incoming packets.
Translated VID This is the VLAN ID that replaces the customer VLAN ID in the tagged packets.
Priority This is the priority level that replaces the customer priority level in the tagged packets.
Commentaires sur ces manuels