ZyXEL Communications GS3700 Series Guide de l'utilisateur télécharger pdf (Page 214)

Chapter 23 AAA

GS3700/XGS3700 Series User’s Guide

214

TCP Port The default port of a TACACS+ server for authentication is 49. You need not change this

value unless your network administrator instructs you to do so.

Shared Secret Specify a password (up to 32 alphanumeric characters) as the key to be shared between

the external TACACS+ server and the Switch. This key is not sent over the network. This

key must be the same on the external TACACS+ server and the Switch.

Delete Check this box if you want to remove an existing TACACS+ server entry from the Switch.

This entry is deleted when you click Apply.

Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses

these changes if it is turned off or loses power, so use the Save link on the top navigation

panel to save your changes to the non-volatile memory when you are done configuring.

Cancel Click Cancel to begin configuring this screen afresh.

Accounting

Server

Use this section to configure your TACACS+ accounting settings.

Timeout Specify the amount of time in seconds that the Switch waits for an accounting request

response from the TACACS+ server.

Index This is a read-only number representing a TACACS+ accounting server entry.

IP Address Enter the IP address of an external TACACS+ accounting server in dotted decimal

notation.

TCP Port The default port of a TACACS+ accounting server is 49. You need not change this value

unless your network administrator instructs you to do so.

Shared Secret Specify a password (up to 32 alphanumeric characters) as the key to be shared between

the external TACACS+ accounting server and the Switch. This key is not sent over the

network. This key must be the same on the external TACACS+ accounting server and the

Switch.

Delete Check this box if you want to remove an existing TACACS+ accounting server entry from

the Switch. This entry is deleted when you click Apply.

Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses

these changes if it is turned off or loses power, so use the Save link on the top navigation

panel to save your changes to the non-volatile memory when you are done configuring.

Cancel Click Cancel to begin configuring this screen afresh.

Table 97 Advanced Application > AAA > TACACS+ Server Setup (continued)

LABEL DESCRIPTION

1 2 ... 209 210 211 212 213 214 215 216 217 218 219 ... 415 416

Pas de commentaire

ZyXEL Communications GS3700 Series Guide de l'utilisateur Page 214