ZyXEL Communications GS3700 Series Guide de l'utilisateur télécharger pdf (Page 381)

100

101

Chapter 51 Configure Clone

GS3700/XGS3700 Series User’s Guide

381

The following table describes the labels in this screen.

Table 197 Management > Configure Clone

LABEL DESCRIPTION

Source/

Destination

Port

Enter the source port under the Source label. This port’s attributes are copied.

Enter the destination port or ports under the Destination label. These are the ports which

are going to have the same attributes as the source port. You can enter individual ports

separated by a comma or a range of ports by using a dash.

Example:

• 2, 4, 6 indicates that ports 2, 4 and 6 are the destination ports.

• 2-6 indicates that ports 2 through 6 are the destination ports.

Basic Setting Select which port settings (configured in the Basic Setting menus) should be copied to the

destination port(s).

Advanced

Application

Select which port settings (configured in the Advanced Application menus) should be

copied to the destination ports.

Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these

changes if it is turned off or loses power, so use the Save link on the top navigation panel to

save your changes to the non-volatile memory when you are done configuring.

Cancel Click Cancel to begin configuring this screen afresh.

1 2 ... 376 377 378 379 380 381 382 383 384 385 386 ... 415 416

Commentaires sur ces manuels

Pas de commentaire

ZyXEL Communications GS3700 Series Guide de l'utilisateur Page 381

Commentaires sur ces manuels