ZyXEL Communications MES-2110 Guide de l'utilisateur télécharger pdf (Page 60)

Chapter 7 Loop Detection

MES-2110 User’s Guide

The following figure shows a loop detection enabled port N on switch A sending a

probe frame P to switch B. Since switch B is in loop state, the probe frame P

returns to port N on A. The Switch then shuts down port N to ensure that the rest

of the network is not affected by the switch in loop state.

Figure 27 Loop detection - Probe Frame

Note: After resolving the loop problem on your network you can re-activate the

disabled port via the web configurator or via commands (See the CLI Reference

Guide).

7.2 The Loop Detection Screen

Click Configuration > Loop Detection to open the following screen.

Figure 28 Configuration > Loop Detection

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 183 184

Pas de commentaire

ZyXEL Communications MES-2110 Guide de l'utilisateur Page 60