ZyXEL Communications MES-2110 Guide de l'utilisateur télécharger pdf (Page 105)

Chapter 15 Link Aggregation

MES-2110 User’s Guide

105

15.6 LACP Link Status

Click Configuration > Trunk Config > LACP Link Status in the navigation

panel to open the following screen.

Figure 52 Configuration > Trunk Config > LACP Link Status

The following table describes the labels in this screen.

System

Priority

LACP system priority is a number between 1 and 65535. The switch with

the lowest system priority (and lowest port number if system priority is the

same) becomes the LACP “server”. The LACP “server” controls the

operation of LACP setup. Enter a number to set the priority of an active

port using Link Aggregation Control Protocol (LACP). The smaller the

number, the higher the priority level.

Undo Click this to restore your last saved settings.

Apply Click this to save your changes.

Table 43 Configuration > Trunk Config > LACP Configuration (continued)

LABEL DESCRIPTION

Table 44 Configuration > Trunk Config > LACP Link Status

LABEL DESCRIPTION

Actor This is the local Switch.

MAC This is the local Switch’s MAC address.

Priority This is the local Switch’s priority level.

Port ID This shows the port number belonging to the trunk group.

Key This is the local Switch’s key value.

Priority This is the port priority level.

Partner This is the peer Switch.

MAC This is the peer Switch’s MAC address.

Priority This is the peer Switch’s priority level.

Port ID This shows the port number belonging to the trunk group.

Key This is the peer Switch’s key value.

Priority This is the port priority level.

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 183 184

Pas de commentaire

ZyXEL Communications MES-2110 Guide de l'utilisateur Page 105