ZyXEL Communications ADSL VoIP IAD with 802.11g Wireless 2602HW Series Guide de l'utilisateur Page 336

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 519
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 335
Prestige 2602HW Series User’s Guide
336 Chapter 33 Filter Configuration
33.4.1 TCP/IP Filter Rule
This section shows you how to configure a TCP/IP filter rule. TCP/IP rules allow you to base
the rule on the fields in the IP and the upper layer protocol, for example, UDP and TCP
headers.
To configure TCP/IP rules, select TCP/IP Filter Rule from the Filter Type field and press
[ENTER] to open Menu 21.1.x.1 – TCP/IP Filter Rule, as shown next.
Figure 191 Menu 21.1.x.1 TCP/IP Filter Rule
The following table describes how to configure your TCP/IP filter rule.
Menu 21.1.1.1 - TCP/IP Filter Rule
Filter #: 1,1
Filter Type= TCP/IP Filter Rule
Active= No
IP Protocol= 0 IP Source Route= No
Destination: IP Addr=
IP Mask=
Port #=
Port # Comp= None
Source: IP Addr=
IP Mask=
Port #=
Port # Comp= None
TCP Estab= N/A
More= No Log= None
Action Matched= Check Next Rule
Action Not Matched= Check Next Rule
Press ENTER to Confirm or ESC to Cancel:
Table 111 Menu 21.1.x.1 TCP/IP Filter Rule
FIELD DESCRIPTION
Filter # This is the filter set, filter rule coordinates, for instance, 2, 3 refers to the second filter
set and the third filter rule of that set.
Filter Type Use [SPACE BAR] and then [ENTER] to choose a rule. Parameters displayed for
each type will be different. Choices are TCP/IP Filter Rule or Generic Filter Rule.
Active Select Yes to activate or No to deactivate the filter rule.
IP Protocol This is the upper layer protocol, for example, TCP is 6, UDP is 17 and ICMP is 1.
The value must be between 0 and 255. A value of 0 matches ANY protocol.
IP Source Route IP Source Route is an optional header that dictates the route an IP packet takes
from its source to its destination. If Yes, the rule applies to any packet with an IP
source route. The majority of IP packets do not have source route.
Destination:
IP Addr Type the destination IP address of the packet you want to filter. This field is ignored
if it is 0.0.0.0.
IP Mask Type the IP mask to apply to the Destination: IP Addr field.
Vue de la page 335
1 2 ... 331 332 333 334 335 336 337 338 339 340 341 ... 518 519

Commentaires sur ces manuels

Pas de commentaire