ZyXEL Communications ADSL VoIP IAD with 802.11g Wireless 2602HW Series Guide de l'utilisateur télécharger pdf (Page 140)

Prestige 2602HW Series User’s Guide

140 Chapter 10 Voice Screens

10.4 Quality of Service (QoS)

Quality of Service (QoS) refers to both a network's ability to deliver data with minimum delay,

and the networking methods used to provide bandwidth for real-time multimedia applications.

10.4.1 Type Of Service (ToS)

Network traffic can be classified by setting the ToS (Type Of Service) values at the data

source (for example, at the Prestige) so a server can decide the best method of delivery, that is

the least cost, fastest route and so on.

Min-SE When two SIP devices negotiate a SIP session, they must negotiate a common

expiration time for idle SIP sessions. This field sets the shortest expiration time that

the Prestige will accept. The Prestige checks the session expiration values of

incoming SIP INVITE requests against the minimum session expiration value that

you configure here. If the session expiration of an incoming INVITE request is less

than the value you configure here, the Prestige negotiates with the other SIP

device to increase the session expiration value to match the Prestige’s minimum

session expiration value.

RTP Port Range Real time Transport Protocol is used to handle voice data transfer. Use these fields

to configure the Prestige’s listening port range for RTP traffic. Leave these fields

set to the defaults if you were not given a range of RTP ports to use.

Preferred

Compression

Type

Use this field to select the type of voice coder/decoder (codec) that you want the

Prestige to use. G.711 provides higher voice quality than G.729 but requires

64kbps of bandwidth while G.729 only requires 8kbps.

Select G.711>G.729 if you want the Prestige to first attempt to use the G.711

codec and then the G.729 codec if the peer is not set up to use G.711.

Select G.711 only if you want the Prestige to only use the G.711 codec when

making VoIP calls. You will not be able to connect to a peer that is not set up to use

G.711.

Select G.729>G.711 if you want the Prestige to first attempt to use the G.729

codec and then the G.711 codec if the peer is not set up to use G.729.

Select G.729 only if you want the Prestige to only use the G.729 codec when

making VoIP calls. You will not be able to connect to a peer that is not set up to use

G.729.

DTMF Mode The Dual Tone Multi-Frequency (DTMF) mode sets how the Prestige handles the

tones that your telephone makes when you push its buttons. It is recommended

that you use the same mode that your VoIP service provider uses.

Select RFC 2833 to send the DTMF tones in RTP packets.

Select PCM (Pulse Code Modulation) to include the DTMF tones in the voice data

stream. This method works best when you are using a codec that does not use

compression (like G.711). Codecs that use compression (like G.729) could distort

the tones.

Select SIP INFO to send the DTMF tones in SIP messages.

Back Click Back to return to the previous screen.

Apply Click Apply to save your changes back to the Prestige.

Cancel Click Cancel to begin configuring this screen afresh.

Table 34 Voice Advanced Setup (continued)

LABEL DESCRIPTION

1 2 ... 135 136 137 138 139 140 141 142 143 144 145 ... 518 519

Commentaires sur ces manuels

Pas de commentaire

ZyXEL Communications ADSL VoIP IAD with 802.11g Wireless 2602HW Series Guide de l'utilisateur Page 140

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau ZyXEL Communications ADSL VoIP IAD with 802.11g Wireless 2602HW Series