ZyXEL Communications G-3000 Guide de l'utilisateur télécharger pdf (Page 48)

ZyAIR G-1000 Access Point User’s Guide

5-8 Wireless Configuration and Roaming

3. The adjacent access points should use different radio channels when their coverage areas overlap.

4. All access points must use the same port number to relay roaming information.

5. The access points must be connected to the Ethernet and be able to get IP addresses from a DHCP

server if using dynamic IP address assignment.

To enable roaming on your ZyAIR, click ADVANCED, WIRELESS and then the Roaming tab. The screen

appears as shown.

Figure 5-7 Roaming

The following table describes the labels in this screen.

Table 5-2 Roaming

LABEL DESCRIPTION

Active

Select Yes from the drop-down list box to enable roaming on the ZyAIR if you have two or

more ZyAIRs on the same subnet.

All APs on the same subnet and the wireless stations must have the

same ESSID to allow roaming.

Port Enter the port number to communicate roaming information between access points. The

port number must be the same on all access points. The default is 16290. Make sure this

port is not used by other services.

Apply

Click Apply to save your changes back to the ZyAIR.

Reset

Click Reset to begin configuring this screen afresh.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 196 197

Pas de commentaire

ZyXEL Communications G-3000 Guide de l'utilisateur Page 48