ZyXEL Communications G-3000 Guide de l'utilisateur télécharger pdf (Page 190)

ZyAIR G-1000 Access Point User’s Guide

K-4 Log Descriptions

Chart 24 Sys log

LOG MESSAGE DESCRIPTION

Mon dd hr:mm:ss hostname

src="<srcIP:srcPort>"

dst="<dstIP:dstPort>"

msg="<msg>" note="<note>"

This message is sent by the "RAS" when this syslog is

generated. The messages and notes are defined in this

appendix’s other charts.

Log Commands

Go to the command interpreter interface (the Command Interpreter Appendix explains how to access and

use the commands).

Configuring What You Want the ZyAIR to Log

Use the sys logs load command to load the log setting buffer that allows you to configure which logs

the ZyAIR is to record.

Use sys logs category followed by a log category and a parameter to decide what to record

Chart 25 Log Categories and Available Settings

LOG CATEGORIES AVAILABLE PARAMETERS

error 0, 1, 2, 3

mten 0, 1

upnp 0, 1

Use 0 to not record logs for that category, 1 to record only logs for that category, 2 to record only

alerts for that category, and

3 to record both logs and alerts for that category.

Use the sys logs save command to store the settings in the ZyAIR (you must do this in order to

record logs).

Displaying Logs

Use the sys logs display command to show all of the logs in the ZyAIR’s log.

Use the sys logs category display command to show the log settings for all of the log

categories.

Use the sys logs display [log category] command to show the logs in an individual ZyAIR

log category.

1 2 ... 185 186 187 188 189 190 191 192 193 194 195 196 197

Pas de commentaire

ZyXEL Communications G-3000 Guide de l'utilisateur Page 190