Zyxel-communications Internet Security Gateway ZyWALL 100 Manuel d'utilisateur Page 95

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 356
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 94
ZyWALL 100 Internet Security Gateway
9-12 Remote Node Setup
9.4 Remote Node Filter
Move the cursor to the field Edit Filter Sets in menu 11.1, then press [SPACE BAR] to set the value to
Yes. Press [ENTER] to open Menu 11.5 - Remote Node Filter.
Use menu 11.5 to specify the filter set(s) to apply to the incoming and outgoing traffic between this remote
node and the ZyWALL to prevent certain packets from triggering calls. You can specify up to 4 filter sets
separated by commas, for example, 1, 5, 9, 12, in each filter field. Note that spaces are accepted in this
field. For more information on defining the filters, please refer to the Filters chapter. For PPPoE or PPTP
encapsulation, you have the additional option of specifying remote node call filter sets.
Figure 9-7 Menu 11.5 — Remote Node Filter (Ethernet Encapsulation)
Figure 9-8 Menu 11.5 — Remote Node Filter (PPPoE or PPTP Encapsulation)
Menu 11.5 - Remote Node Filter
Input Filter Sets:
protocol filters=
device filters=
Output Filter Sets:
protocol filters=
device filters=
Enter here to CONFIRM or ESC to CANCEL:
Menu 11.5 - Remote Node Filter
Input Filter Sets:
protocol filters=
Device filters=
Output Filter Sets:
protocol filters=
device filters=
Call Filter Sets:
protocol filters=
Device filters=
Enter here to CONFIRM or ESC to CANCEL:
Vue de la page 94
1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 355 356

Commentaires sur ces manuels

Pas de commentaire