Zyxel-communications Internet Security Gateway ZyWALL 100 Manuel d'utilisateur Page 196

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 356
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 195
ZyWALL 100 Internet Security Gateway
Filter Configuration 19-1
Chapter 19
Filter Configuration
This chapter shows you how to create and apply filters.
19.1 About Filtering
Your ZyWALL uses filters to decide whether to allow passage of a data packet and/or to make a call. There
are two types of filter applications: data filtering and call filtering. Filters are subdivided into device and
protocol filters, which are discussed later.
Data filtering screens the data to determine if the packet should be allowed to pass. Data filters are divided
into incoming and outgoing filters, depending on the direction of the packet relative to a port. Data filtering
can be applied on either the WAN side or the LAN side. Call filtering is used to determine if a packet
should be allowed to trigger a call. Remote node call filtering is only applicable when using PPPoE
encapsulation. Outgoing packets must undergo data filtering before they encounter call filtering as shown in
the following figure.
Vue de la page 195
1 2 ... 191 192 193 194 195 196 197 198 199 200 201 ... 355 356

Commentaires sur ces manuels

Pas de commentaire