ZyXEL Communications PLA-470 V2 - V3.0.5 Guide d'installation Page 288

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 349
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 287
Configuring a DHCP/NAT Server
Most Linux distributions propose a DHCP server called dhcpd.
The configuration of the DHCP server just requires the creation of a dhcpd.conf
configuration file which will be placed in the directory.
Here is an example of dhcpd.conf file:
subnet 10.0.0.0 netmask 255.255.255.0 {
range 10.0.0.2 10.0.0.50;
option routers 10.0.0.1;
option domain-name-servers 10.0.0.60;
default-lease-time 1000
max-lease-time 3600
}
Subnet is used for defining the network address used by IP addresses.
Netmask defines the subnet mask.
Range defines the address range given by the dhcpd server.
Option routers defines the IP address of the default gateway.
Option domain-name-servers defines the DNS address.
Default-lease-time defines the default lease time, in this case 1,000 seconds.
Max-lease-time defines the maximum lease time.
The dhcpd server can be started whenever the Internet gateway is switched on
by entering the following line:
# dhcpd eth0
where eth0 is the Ethernet interface connected to the gateway.
Configuring a DHCP Client Under Linux 269
Figure 11.17 Internet access with confidentiality between computers
Vue de la page 287
1 2 ... 283 284 285 286 287 288 289 290 291 292 293 ... 348 349

Commentaires sur ces manuels

Pas de commentaire