ZyXEL Communications omni.net Guide de l'utilisateur télécharger pdf (Page 36)

Omni.Net Lite User’s Guide

35 Chapter 2 Using the Utility

Note: The high threshold must be greater than the low threshold, otherwise, both of

them will be reset to the default.

2.5.4 Configuring PPP/MP Parameters

Click PPP/MP Parameters under RS-232 Port to display the screen as shown next.

Figure 10 RS-232 Port: PPP/MP Parameters

The following table describes the labels in this screen.

Table 6 RS-232 Port: PPP/MP Parameters

LABEL DESCRIPTION

Enable Fixed MP

(fixed 128K)

Select this option to combine both B-channels into one PPP link for data calls

and always has the higher transmission rate.

Enable CHAP Select this option to have your TA use CHAP for link authentication with the

username and/or password.

Enable Call Bumping Select this option to allow bandwidth release for voice calls.

Maximum throughput

(1 or 2 B-channel)

This field is not available if you select Enable Fixed MP.

Select 64 kbps (1 B-channel) to activate only one B-channel and transmit

data at 64 kbps.

Select 128 kbps (2 B-channel) if if you want to bundle two B-channels to

increase the data transfer rate. This is called multilink.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 83 84

Pas de commentaire

ZyXEL Communications omni.net Guide de l'utilisateur Page 36