ZyXEL Communications G-3000 Guide de l'utilisateur télécharger pdf (Page 103)

G-3000H User’s Guide

Chapter 8 Other Wireless Configurations 103

CHAPTER 8

Other Wireless Configurations

This chapter describes how to configure the Layer-2 Isolation, MAC Filter and Roaming

screens on your ZyAIR.

8.1 Layer-2 Isolation Introduction

Layer-2 isolation is used to prevent wireless clients associated with your ZyAIR from

communicating with other wireless clients, AP’s, computers or routers in a network.

In the following figure, A represents your ZyAIR, B represents an AP, C represents a server

and 1, 2 and 3 represent wireless clients. If layer-2 isolation is enabled on the ZyAIR (A), then

wireless clients 1 and 2 cannot communicate with B, C or 3. Wireless clients 1 and 2 cannot

communicate with each other unless you enable Intra-BSS in the Wireless configuration

screen.

Note: In the Wireless configuration screen, the Enable Intra-BSS Traffic check box is

cleared when you enable layer-2 isolation.

If you want 1 and 2 to be able to communicate with C, B and/ or 3 then enter the MAC

addresses of C, B and/or 3 in the Allow devices with these MAC addresses table.

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 287 288

Pas de commentaire

ZyXEL Communications G-3000 Guide de l'utilisateur Page 103