ZyXEL Communications G-102 - V1.0 Guide de l'utilisateur télécharger pdf (Page 259)

Chapter 73 Additional Commands

Ethernet Switch CLI Reference Guide

259

This example displays run-time SFP (Small Form Facter Pluggable) parameters on ports 9 (the

first SFP port 0, with an SFP transceiver installed) and 10 (the second SFP port 1, no SFP

transceiver installed) on the

Switch. You can also see the alarm and warning threasholds for

temperature, voltage, transmission bias, transmission and receiving power as shown.

This example runs an internal loopback test on ports 3-6.

This example displays route information to an Ethernet device with IP address

192.168.1.100.

sysname# show sfp 9-10

SFP : 0

Part Number : SFP-SX-DDM

Series Number : S081113001132

Revision : V1.0

Transceiver : 1000BASE-SX

Temperature(C) Alarm(80.00 ~ 0.00), Warning(75.00 ~ 5.00), Current(38.00)

Voltage(V) Alarm(3.50 ~ 3.10), Warning(3.45 ~ 3.15), Current(3.37)

Tx Bias(mA) Alarm(100.05 ~ 1.00), Warning(90.04 ~ 2.00), Current(5.25)

Tx Power(dBm) Alarm(-2.99 ~ -8.98), Warning(-3.49 ~ -8.48), Current(-6.05)

Rx Power(dBm) Alarm(-2.99 ~ -18.01), Warning(-3.49 ~ -17.39), Current(-4.24)

SFP : 1

Not Available

sysname# test interface port-channel 3-6

Testing internal loopback on port 3 :Passed!

Ethernet Port 3 Test ok.

Testing internal loopback on port 4 :Passed!

Ethernet Port 4 Test ok.

Testing internal loopback on port 5 :Passed!

Ethernet Port 5 Test ok.

Testing internal loopback on port 6 :Passed!

Ethernet Port 6 Test ok.

sysname> traceroute 192.168.1.100

traceroute to 192.168.1.100, 30 hops max, 40 byte packet

1:192.168.1.100 (10 ms) (10 ms) (0 ms)

traceroute done:

sysname>

1 2 ... 254 255 256 257 258 259 260 261 262 263 264 ... 285 286

Pas de commentaire

ZyXEL Communications G-102 - V1.0 Guide de l'utilisateur Page 259