Zyxel-communications Network Device NXC-8160s Manuel d'utilisateur télécharger pdf (Page 3)

ENGLISH

1 Make Initial Hardware Connections

Follow the steps below to connect your NXC-8160 for initial configurations.

1 Connect an AP(s) to the WLAN port(s) using the included Ethernet cable. At the time of

writing, you can connect only the NWA-8500 model to the WLAN port.

2 Connect your computer to the LAN port using an Ethernet cable.

3 Connect the power socket on the rear panel to a power source using the included

power cord.

After you have connected the power and turned on the power source, check the LEDs

(lights) on the front panel. The POWER LED turns on. The LINK/ACT and LINK LEDs turn

on when the corresponding ports are connected properly.

1 2 3 4 5 6 7 8 ... 66 67

Pas de commentaire

Zyxel-communications Network Device NXC-8160s Manuel d'utilisateur Page 3