ZyXEL Communications P-660 series Guide de l'utilisateur télécharger pdf (Page 171)

Chapter 13 Remote Management Configuration

P-660R-F1 Series User’s Guide

171

13.6.3 Configuring SNMP

To change your ZyXEL Device’s SNMP settings, click Advanced > Remote MGMT > SNMP. The

screen appears as shown.

Figure 103 Remote Management: SNMP

The following table describes the labels in this screen.

Table 65 Remote Management: SNMP

LABEL DESCRIPTION

SNMP

Port You may change the server port number for a service if needed, however you

must use the same port number in order to use that service for remote

management.

Access Status Select the interface(s) through which a computer may access the ZyXEL Device

using this service.

Secured Client IP A secured client is a “trusted” computer that is allowed to communicate with

the ZyXEL Device using this service.

Select All to allow any computer to access the ZyXEL Device using this service.

Choose Selected to just allow the computer with the IP address that you

specify to access the ZyXEL Device using this service.

SNMP Configuration

Get Community Enter the Get Community, which is the password for the incoming Get and

GetNext requests from the management station. The default is public and

allows all requests.

Set Community Enter the Set community, which is the password for incoming Set requests

from the management station. The default is public and allows all requests.

Trap

Community Type the trap community, which is the password sent with each trap to the

SNMP manager. The default is public and allows all requests.

1 2 ... 166 167 168 169 170 171 172 173 174 175 176 ... 267 268

Pas de commentaire

ZyXEL Communications P-660 series Guide de l'utilisateur Page 171