ZyXEL Communications G-570U Guide de l'utilisateur télécharger pdf (Page 31)

ZyXEL G-570U User’s Guide

Chapter 2 Management Computer Setup 31

CHAPTER 2

Management Computer Setup

This chapter describes how to prepare your computer to access the G-570U web configurator.

2.1 Introduction

You can connect a computer to the G-570U for management purposes either using an Ethernet

connection (recommended for a first time management session) or wirelessly.

2.2 Wired Connection

You must prepare your computer/computer network to connect to the G-570U if you are using

a wired connection. Your computer's IP address and subnet mask must be on the same subnet

as the G-570U. This can be done by setting up your computer's IP address.

The following figure shows you an example of accessing your G-570U via a wired connection

with an Ethernet cable.

Figure 10 Wired Connection

2.2.1 Setting Up Your Computer's IP Address

Note: Skip this section if your computer's IP address is already between 192.168.1.3

and 192.168.1.254 with subnet mask 255.255.255.0.

Your computer must have a network card and TCP/IP installed. TCP/IP should already be

installed on computers using Windows NT/2000/XP, Macintosh OS 7 and later operating

systems. Refer to the appendix about setting up your computer's IP address for other operating

systems.

192.168.1.3

Default IP Address:

192.168.1.2

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 161 162

Pas de commentaire

ZyXEL Communications G-570U Guide de l'utilisateur Page 31