ZyXEL Communications Parental Control Gateway HS100/HS100W Guide de l'utilisateur télécharger pdf (Page 101)

HomeSafe User’s Guide

7-8 Wireless Security

7.6 Configuring WPA-PSK Authentication

In order to configure and enable WPA-PSK Authentication; click the WIRELESS link under

ADVANCED to display the Wireless screen. Select WPA-PSK from the Security list.

Figure 7-6 WLAN : Wireless : WPA-PSK

The following table describes the labels in this screen.

Table 7-4 WLAN : Wireless : WPA-PSK

LABEL DESCRIPTION

Pre-Shared Key

The encryption mechanisms used for WPA and WPA-PSK are the same. The only

difference between the two is that WPA-PSK uses a simple common password,

instead of user-specific credentials.

Type a pre-shared key from 8 to 63 case-sensitive ASCII characters (including

spaces and symbols).

ReAuthentication

Timer (in

seconds)

Specify how often wireless stations have to reenter usernames and passwords in

order to stay connected. Enter a time interval between 10 and 9999 seconds. The

default time interval is 1800 seconds (30 minutes).

) If wireless station authentication is done

using a RADIUS server, the reauthentication

timer on the RADIUS server has priority.

Idle Timeout The HomeSafe automatically disconnects a wireless station from the wired network

after a period of inactivity. The wireless station needs to enter the username and

password again before access to the wired network is allowed. The default time

interval is 3600 seconds (or 1 hour).

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 356 357

Pas de commentaire

ZyXEL Communications Parental Control Gateway HS100/HS100W Guide de l'utilisateur Page 101