ZyXEL Communications Omni 288S Manuel d'utilisateur télécharger pdf (Page 18)

novaPro32 Routel

Routel set-up

7000991003 Q2

Sauter Systems

3.3 Routel mode

The EYZ291 F001 novaNet Router has to be set to Routel mode and the baud rate

needs be set (38400 Baud recommended):-

Setting switch 1 to ‘on’ (Switches down = On ) enables the Routel mode (dialling

enabled).

Select the speed with the appropriate speed switch. (Setting none of the speed switches

sets the speed to 9600.)

The modem will auto-adapt to the baud rate of the Routel at Power-On of the Routel or

of the modem (the Routel sends the Init string to the modem when DSR goes active).

(Only if the 291 is in ‘Routel’ mode. If the ‘Routel’ switch is not set, the Router will not

send any Init string to the modem and the baud rate of the modem has to be configured

(cf. Ch. 4.3.)

You may find that your EYZ291 has a label such as this:-

This is an old label (fits with ‘a’ EPROM) and should be replaced.

(

Switches down = On

)

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 33 34

Pas de commentaire

ZyXEL Communications Omni 288S Manuel d'utilisateur Page 18