ZyXEL Communications NETATLAS ENTERPRISE - Guide de l'utilisateur télécharger pdf (Page 152)

NetAtlas Enterprise Ethernet Switch Manager User’s Guide

Chapter 17 Routing Configuration 152

Destination IP

Address

This parameter specifies the IP network address of the final destination. Routing is

always based on network number. If you need to specify a route to a single host, use a

subnet mask of 255.255.255.255 in the subnet mask field to force the network number

to be identical to the host ID.

IP Subnet

Mask

Enter the subnet mask for this destination.

Gateway IP

Address

Enter the IP address of the gateway. The gateway is an immediate neighbor of your

switch that will forward the packet to the destination. The gateway must be a router on

the same segment as your switch.

Metric The metric represents the “cost” of transmission for routing purposes. IP routing uses

hop count as the measurement of cost, with a minimum of 1 for directly connected

networks. Enter a number that approximates the cost for this link. The number need not

be precise, but it must be between 1 and 15. In practice, 2 or 3 is usually a good

number.

OK Click OK to save the new rule to the switch. It then displays in the Routing

Configuration screen.

Cancel Click Cancel to discard all changes and close the screen.

Table 76 Routing Configuration: Static Route: Add or Modify (continued)

LABEL DESCRIPTION

1 2 ... 147 148 149 150 151 152 153 154 155 156 157 ... 178 179

Pas de commentaire

ZyXEL Communications NETATLAS ENTERPRISE - Guide de l'utilisateur Page 152