ZyXEL Communications IES-1248-51 Guide de l'utilisateur Page 284

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 654
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 283
Chapter 38 IP Bridge
IES-1248-51V User’s Guide
284
38.4 IPB Edge Router Screen
Use this screen to set up and maintain edge routers in an IP bridge. Edge routers
are usually the gateways that are provided to the subscribers. They can also be
the gateways that are specified in static routing table entries. If two edge routers
are in different domains, it is possible for them to have the same IP address.
To open this screen, click Advanced Application > IP Bridge > Edge Router.
Figure 133 IPB Edge Router
The following table describes the labels in this screen.
Table 89 IPB Edge Router
LABEL DESCRIPTION
Edge Router IP Enter the IP address of the edge router.
NetMask Enter the number of bits in the subnet mask of the edge router.
VID Enter the ID of the VLAN of which the edge router is a member. The
IES-1248-51V uses this VLAN ID when it forwards frames to the edge
router. It also uses the VLAN ID to identify the domain the edge router
is in. You have to add the VLAN ID to an IP bridge domain before you
can enter it here.
Add Click Add to create the edge router. It is then displayed in the
summary table at the bottom of the screen.
Clicking Add saves your changes to the IES-1248-51V’s volatile
memory. The IES-1248-51V loses these changes if it is turned off or
loses power, so use the Config Save link on the navigation panel to
save your changes to the non-volatile memory when you are done
configuring.
Vue de la page 283
1 2 ... 279 280 281 282 283 284 285 286 287 288 289 ... 653 654

Commentaires sur ces manuels

Pas de commentaire