ZyXEL Communications ES-2024 Series Guide de l'utilisateur télécharger pdf (Page 58)

ES-4024A User’s Guide

Chapter 5 Initial Setup Example 57

CHAPTER 5

Initial Setup Example

This chapter shows how to set up the switch for an example network.

5.1 Overview

The following lists the configuration steps for the example network:

• Configure an IP interface

• Configure DHCP server settings

• Create a VLAN

• Set port VLAN ID

5.1.1 Configuring an IP Interface

On a layer-3 switch, an IP interface (also known as an IP routing domain) is not bound to a

physical port. The default IP address of the switch is 192.168.1.1 with a subnet mask of

255.255.255.0.

In the example network, since the RD network is already in the same IP interface as the

switch, you don’t need to create an IP interface for it. However, if you want to have the Sales

network on a different routing domain, you need to create a new IP interface. This allows the

switch to route traffic between the RD and Sales networks.

Figure 24 Initial Setup Network Example: IP Interface

1 Connect your computer to any Ethernet port on the switch. Make sure your computer is

in the same subnet as the switch.

2 Open your web browser and enter 192.168.1.1 (the default IP address) in the address bar

to access the web configurator. See Section 4.2 on page 49 for more information.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 283 284

Pas de commentaire

ZyXEL Communications ES-2024 Series Guide de l'utilisateur Page 58