Zyxel-communications ISDN Terminal Adapter Omni.Net Lite Manuel d'utilisateur télécharger pdf (Page 61)

Omni.Net Lite User’s Guide

Chapter 3 Using AT Commands 60

\Zd=<phone

number> [/<sub-

address>]

Set a pre-stored phone number for the analog port.

d: 0-4

<phone number>: Enter up to 32 characters, including digits from 0 to 9, *, #,

hyphen ( -), comma (,) and (‘,’). [‘,’] will be ignored.

<sub-address>: Enter up to 20 ASCII characters ranging from “0-9”,” a-z” and

“A-Z”.

!pA0=n Set the device type of the analog equipment connected to the analog port.

p: enter 1 or 2 to specify the analog port.

n=0: indicates a telephone, telephone with caller ID (type 1), G3 fax or modem

(default).

n=2: indicates a telephone with call waiting caller ID (type 2).

!pA1=n p: enter 1 or 2 to specify the analog port.

n=0: Disable call waiting.

n=1: Enable call waiting (default).

!pId=<phone

number> [/<sub-

address>]

Create a list of the phone numbers for incoming call screening on the analog

port.

p: enter 1 or 2 to specify the analog port.

d=0-4.

<phone number>: Enter up to 32 characters, including digits from 0 to 9, *, #,

hyphen ( -), comma (,) and (‘,’). [‘,’] will be ignored.

<sub-address>: Enter up to 20 ASCII characters ranging from “0-9”,” a-z” and

“A-Z”.

!pOd=<prefix digits> Create a list of the prefix digits for outgoing call screening on the analog port.

p: enter 1 or 2 to specify the analog port.

d=0-2

!pP0=n Set incoming call screen mode for the analog port.

p: enter 1 or 2 to specify the analog port.

n=0: Accept all incoming calls (default).

n=1: Reject all incoming calls.

n=2: Only accept the calls from the phone number in the list (see !pId=<phone

number> [/<sub-address>]).

n=3: Only reject the calls from the phone number in the list (see !pId=<phone

number> [/<sub-address>]).

!pP1=n Set outgoing call screen mode for the analog port.

p: enter 1 or 2 to specify the analog port.

n=0: No restriction (default).

n=1: Prohibit all outgoing calls.

n=2: Only accept the calls with the prefix in the pre-defined list (see

!pOd=<prefix digits>).

n=3: Only reject the calls with the prefix in the pre-defined list (see

!pOd=<prefix digits>).

!pP2=n Select CLIP (Calling Line Identification Presentation) or CLIR (Calling Line

Identification Restriction) for the analog port.

p: enter 1 or 2 to specify the analog port.

n=0 indicates you select CLIR and the ISDN switch will not pass your phone

number to the destination site.

n=1 indicates you select CLIP and the ISDN switch will pass your phone number

to the destination site.

Table 15 AT Command Sets for the Analog Port

COMMAND DESCRIPTION

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 83 84

Commentaires sur ces manuels

Pas de commentaire

Zyxel-communications ISDN Terminal Adapter Omni.Net Lite Manuel d'utilisateur Page 61

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel Zyxel-communications ISDN Terminal Adapter Omni.Net Lite