Zyxel-communications G.SHDSL.bis 4-port Security Gateway P-793H Manuel d'utilisateur Page 252

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 432
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 251
P-793H User’s Guide
252 Chapter 22 General Setup
22.1.1 Configuring Dynamic DNS
To configure Dynamic DNS, set the ZyXEL Device to router mode in menu 1 or in the
MAINTENANCE Device Mode screen and go to Menu 1 - General Setup and press
[SPACE BAR] to select Yes in the Edit Dynamic DNS field. Press [ENTER] to display
Menu 1.1 - Configure Dynamic DNS (shown next).
Figure 137 Menu 1.1: Configure Dynamic DNS
Route IP Select Yes to enable IP-based routing in the ZyXEL Device. This is not effective for
a specific remote node unless you enable IP-based routing in the remote node too.
See Menu 11.1: Remote Node Profile (nodes 1-7) in Section 26.3 on page 269.
You should enable Route IP, Bridge, or both in this screen. If you disable Route IP
and Bridge, the device does not send traffic between the LAN ports and remote
node.
Bridge If Route IP is Yes, select Yes in this field to enable bridging in the ZyXEL Device for
protocols that are not supported by IP-based routing (for example, SNA).
If Route IP is No, select Yes in this field to enable bridging in the ZyXEL Device for
all protocols.
In either case, this setting is not effective for a specific remote node unless you
enable bridging in the remote node too. See Menu 11.1: Remote Node Profile
(nodes 1-7) in Section 26.3 on page 269.
You should enable Route IP, Bridge, or both in this screen. If you disable Route IP
and Bridge, the device does not send traffic between the LAN ports and remote
node.
When you have completed this menu, press [ENTER] at the prompt “Press ENTER to Confirm…” to
save your configuration, or press [ESC] at any time to cancel.
Table 91 Menu 1: General Setup (continued)
FIELD DESCRIPTION
Menu 1.1 - Configure Dynamic DNS
Service Provider= WWW.DynDNS.ORG
Active= No
DDNSType= DynamicDNS
Host 1=
Host 2=
Host 3=
Username=
Password= ********
Enable Wildcard Option= No
Enable Off Line Option= N/A
IP Address Update Policy:
DDNS Server Auto Detect IP Address= No
Use Specified IP Address= No
Use IP Address= N/A
Vue de la page 251
1 2 ... 247 248 249 250 251 252 253 254 255 256 257 ... 431 432

Commentaires sur ces manuels

Pas de commentaire