Zyxel-communications ACCESSING INTERNET & INTRANET omni series Manuel d'utilisateur Page 111

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 168
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 110
Upgrading Your omni 99
2. Start any communications program that supports the Xmodem
protocol, and type:
ATUPX<Enter>
TA responds:
You have chosen Xmodem (128 octets of data with
checksum) protocol to update your TA. Data in Flash ROM
will be erased !!!
Are you sure (Y/N) ?
3. Press Y. The following message then appears:
Start programming, please upload.
4. Use the Xmodem protocol to upload the file ONETd.vvv to your
TA. This step updates the TAs flash EPROM with the new
firmware. When installation is complete, the TA will restart
automatically.
Kernel Mode
In the unlikely event that your TA fails to respond to AT commands
after upgrading the flash EPROM follow the procedure below:
1. Power on the TA. The reset will prompt the TA to check the
integrity of the codes in the flash EPROM.
2. If proper valid firmware can not be verified, the TA will initiate
Kernel Mode. Once it is in Kernel mode, you can issue limited
AT commands. From this point, you can start from item 3 of
our upgrading procedure.
Vue de la page 110
1 2 ... 106 107 108 109 110 111 112 113 114 115 116 ... 167 168

Commentaires sur ces manuels

Pas de commentaire