Zyxel-communications NPS-520 Manuel d'utilisateur télécharger pdf (Page 43)

Chapter 3 Web Configurator

NPS-520 User’s Guide

Figure 22 Network Temporarily Disconnected

After you see the Upgrade Successful screen, wait 30 seconds before logging into the NPS-

520 again.

Figure 23 Firmware Upload Successful

After 30 seconds, log in again and check your new firmware version in the Status screen.

3.7.2 Load Defaults

Click Utilities > Load Defaults to open the following screen. Click the Reset button to clear

all user-entered configuration information and return the NPS-520 to its factory defaults as

shown on the screen.

Figure 24 Web Configurator: Utilities > Load Defaults

You can also press the hardware Reset button to reset the factory defaults of your NPS-520.

Refer to Section 1.5 on page 18 for more information on the Reset button.

3.7.3 Restart Screen

System restart allows you to reboot the NPS-520 without turning the power off.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 111 112

Pas de commentaire

Zyxel-communications NPS-520 Manuel d'utilisateur Page 43